Assembly Instructions

FEATURES :
Plastic tree stand - 3 legs
Spiral Light Unit - Consist of metal spiral frame , soft tape light & star tree topper
CUL in/outdoor adaptor
Sectional metal trunk ( metal pipe )
Metal Lawn Stake - 3 pieces
ASSEMBLY :
STEP 1 - Assemble Tree Stand
1. Upside down put center piece on floor . (Fig. #1)
2. Slide 3 legs one by one into that 3 notches of center piece. Notches are where constructed around center piece. (Fig. #2)
3. Turn over assembled tree stand unit and put it on flat surface floor. (Fig. #3)
STEP 2 - Assemble Trunk with Tree Stand
1. Grip one piece of trunk and turn tapper end downward. Straightly push down end of trunk into hold at center piece of tree stand. (Fig#4)
2. If there were more than one piece of trunk, get trunk tapper end upward and straightly adapt down end onto tapper end of down piece of trunk.
STEP 3 - Assemble Spiral Light Unit with Trunk
1. Hook spiral light unit on top of trunk and gently hanging down. Then, adapt tree topper onto top of trunk.(FIG#5)
2. Fasten spiral light unit on hooking up string with hanger on tree stand. ( Fig# 6 )
STEP 4 - Assemble Adaptor with Spiral Light Unit
1. Plug that male 2 pins connector into female connector where is at end of lead wire .
2. Plug one other end of male connector into female connector at outlet of adaptor.
CAUTION : Check every connector is secured tightly.
WARNING : DO NOT PLUG BEFORE ASSEMBLY
LIGHT UP TREE :
Plug adaptor to 120VAC standard power outlet to light up tree. ( There is no switch constructed on lead wire or adaptor. )
CAUTION :
WHEN SET UP TREE OUTDOOR, PLEASE ASSEMBLE TREE STAND WITH LAWN STAKE AND STICK STAKE INTO GROUND. (FIG#7)
WARANING :
THIS IS NOT TOY , STAY CHILD AWAY. DO NOT PLUG UNDER THUNDER WHEATHER.
3FT SPIRAL TREE ASSEMBLY MANUAL
Fig. #1
Fig. #2
Fig. #3 Fig. #4 Fig. #5 Fig. #6 Fig. #7