Assembly Instructions

ManualsBrandsEnchanted Garden ManualsFountains & Accessories34.5" Carlotta Outdoor Water Fountain

Step 1

Run the cable from the pump and pass through the white pvc

pipe opening (ex. 1). Now pull the pump cable through the white

pvc pipe opening from the base bottom. Next, run the pump

cable through the cable notch on base bottom (ex. 2). Make

sure that the pump is sitting on the bottom of the pot and is

not elevated. Put the black plastic cap onto the white pvc pipe

making sure to place the chord into the notch on the cap (ex. 3).

Step 3

Place the middle, medium sized pot section onto the base/

largest pot (ex. 4). Next, pull out the pump and place to the

side (ex. 5/6).

Step 5

Very Important! To adjust/control the water

ow on your Carlotta fountain, turn the

red water ow control knob to increase or

decrease water ow. The correct ow is

when there is no splash or water loss from

excessive splashing. It is best to have the

water bubble up just enough, and set to

your liking.

Step 4

Connect the hose coming from inside the top smallest pot to

the clear hard plastic water valve (it has the red water ow

controller on it, ex. 7). Next, place the water pump back inside

the basin. Again, making sure that it is resting at the bottom

of the largest base pot (ex. 8). Lastly, now put the top smallest

pot on top of the medium middle pot section (ex. 9). Check to

make sure that all three sections are stacked correctly before

lling with water and plugging in.

Step 6

Use the black plastic shims (that are included) if needed

to adjust the level of the fountain. For best results, the

fountain should be completely level. Shims can be placed

under the base or jar as needed.

ex. 1 ex. 2

ex. 4 ex. 5 ex. 6

ex.3

Step 2

Attach the hose to the

pump and tightly fasten

the clamp with the tool

provided (see image).

Assembly Instructions

Item #2775229

Cascading

Carlotta

Fountain

!WARNING!

• Pump must always be fully submersed in water.

Allowing it to run dry will result in pump failure, voiding the warranty.

• This fountain must be properly stored for freezing conditions. All water must be completely drained and the

pump removed. Store so that water can not enter into basin. If unit is to stay outside, it must be covered with a

waterproof tarp. It should also be raised above the ground. All water must be completely removed from the unit

to prevent cracking or damage.

• Risk of electric shock! Regularly inspect cord and pump for damage or exposed wires. Failure to do so may

result in injury or bodily harm.

ex. 7 ex. 8 ex. 9

Summary of content (1 pages)

PAGE 1
Assembly Instructions Cascading Carlotta Fountain Item #2775229 Step 1 Run the cable from the pump and pass through the white pvc pipe opening (ex. 1). Now pull the pump cable through the white pvc pipe opening from the base bottom. Next, run the pump cable through the cable notch on base bottom (ex. 2). Make sure that the pump is sitting on the bottom of the pot and is not elevated. Put the black plastic cap onto the white pvc pipe making sure to place the chord into the notch on the cap (ex. 3). ex.