Installation Instructions

Assembling & Using Your Product

Unpack all components carefully. Please check to ensure all parts have been removed

from the packaging. There some splashing may occur.

Components:

A Fountain

B Dual 2-Prong Light Connector

C Submersible Pump

D Transformer

E Basin

Assembling:

Place the fountain base on a smooth & level surface.

1 Remove the submersible pump (C) from its packaging and adjust the flow

control to the lowest setting to avoid splashing during fountain assembly. Then,

find the vinyl tubing located inside of the opening on the back of the fountain (A)

and connect it to the submersible pump (See diagram above).

2 Next, connect the dual 2-prong light connector (B) to the transformer (D) by

running the cord through the tube tunnel inside the basin (E) and out towards the

bottom. Then insert the 2-prong female socket into the male plugs of the

transformer (See diagram below).