Assembly Instructions

Assembly Instructions
Item#: Y95826
* * WARNING * *
Read these instructions carefully and keep the fountain power off until the
following assembly process is strictly completed.
Step (1) Match the upper set with the base one and meanwhile put the PVC tube & cable line in the
whole of the base set. See picture
① & ② & ③.
Step (2) Make sure the upper set can match with the base well, see picture
④ & ⑤.
Step (3) Pull out the PVC tube from the back door of the fountain, then connect it with the pump, which
is shown in ⑥.
Step (4) Pull out the cable line of the light from the back door of the fountain, then connect the
connector of LED light to the adaptor, shown in
⑦.
Step (5) Closed up the back cover to the fountain as shown in
⑧.
Step (6) Fill the reservoir with clean water carefully. Always make sure the water is high enough to
submerge the pump completely. This ensures the pump can work properly and prevents
damage to the pump. Plug the pump and adaptor then switch on, the water will start to
flow
in minutes, and lights will be shining instant
ly.

Adjust the pump flow rate to achieve the desired effect and to minimize any splashing, shown as (F).
Splashing can occur if the flow rate is too high or the reservoir is too full. The flow rate can be
increased or decreased by moving the flow rate control slider on the pump body. Moving the slider
towards ‘+/Max.’ will increase the flow rate and moving it towards ‘-/Min’ will decrease it.
On some type of pumps, the flow regulato
r may be turned clockwise or counterclockwise to adjust.
1
Notes:
Choose an appropriate location for the fountain.
Excessive weight or pressure on any of the fountain sections may cause it to fall. Keep pets, children, or
anyone from sitting, leaning, or climbing on any of the fountain components.
While fountain is designed to operate as splash free as possible, some water splashing out of the
fountain is inevitable. Place the fountain in a location where any splashing will not cause damage.
The National Electric Code requires that a ground fault circuit interrupter (GFCI) be used in the branch
circuit supplying fountain pump and other pond equipment. Seek your electrical
supplies dealer for this
device.
Always keep the fountain working with su
nt water and clean of debris and dirt to ensure proper
functioning of the pump.
If necessary, clean the fountain with a soft cloth and change the water frequently. Due to water
evaporation, you may see a buildup of white residue on the fountain surface from mineral content in the
water supply. To prevent such buildup, regularly clean the fountain with soap and water. Do not use any
abrasive, which may damage the applied
nish.
Use of w
er or algaecide of any kind will damage the paint on the fountain and will not
be covered under the manufactures warranty.
See the pump instructions for pump safety, maintenance, and warranty information.
Keep this manual for future reference.
Installation & Assembly
Place the fountain on a level surface, away from areas where it is likely to get clogged with leaves and
make sure that the cable will reach the socket.
Take out all the packaged parts from the carton.
Follow steps to assemble as illustrated below.
•
•
•
•
•
•
•
•
•
•
•
•