Assembly Instructions

Item#:Y95858

* * WARNING * *

Read these instructions carefully and keep the fountain power off until the following

assembly process is strictly completed.

Notes:

 Choose an appropriate location for the fountain.

 Excessive weight or pressure on any of the fountain sections may cause it to fall. Keep pets, children, or

anyone from sitting, leaning, or climbing on any of the fountain components.

 While fountain is designed to operate as splash free as possible, some water splashing out of the

fountain is inevitable. Place the fountain in a location where any splashing will not cause damage.

 The National Electric Code requires that a ground fault circuit interrupter (GFCI) be used in the branch

circuit supplying fountain pump and other pond equipment. Seek your electrical supplies dealer for this

device.

 Always keep the fountain working with sufficient water and clean of debris and dirt to ensure proper

functioning of the pump.

 If necessary, clean the fountain with a soft cloth and change the water frequently. Due to water

evaporation, you may see a buildup of white residue on the fountain surface from mineral content in the

water supply. To prevent such buildup, regularly clean the fountain with soap and water. Do not use any

abrasive, which may damage the applied finish.

 Use of water clarifier or algaecide of any kind will damage the paint on the fountain and will not

be covered under the manufactures warranty.

 See the pump instructions for pump safety, maintenance, and warranty information.

 Keep this manual for future reference.

Installation & Assembly

 Place the fountain on a level surface, away from areas where it is likely to get clogged with leaves and

make sure that the cable will reach the socket.

 Take out all the packaged parts from the carton.

 Follow steps to assemble as illustrated below.

Step (1) Insert the shorter white bucket into the pipe, and fasten tightly using screws provided.

Step (2) Insert the shorter grey bucket into the pipe, and fasten tightly using screws provided.

Step (3) Insert the longer grey bucket into the pipe, and fasten tightly using screws provided. We marked

each set of bucket and pipe in 1/1, 2/2, 3/3, 4/4 for easy identifying.

Step (4) Connect flexible hose with longer white bucket marked 4.

Step (5) Insert the flexible hose into the pipe marked 4.

Step (6) Connect the flexible hose with pump. Pull power cord of pump out through the hole on back side of

the base, being sure pump remains inside of base.

Step (7) Place the top buckets feature on base.

Fill the reservoir with clean water carefully or pipe water into fountain from the front. Always make sure the

water is high enough to submerge the pump completely. This ensures the pump can work properly and

prevents damage to the pump. Plug the pump and adaptor then switch on, the water will start to flow in

minutes.

 Adjust the pump flow rate to achieve the desired effect and to minimize any splashing. Splashing

can occur if the flow rate is too high or the reservoir is too full. The flow rate can be increased or

decreased by moving the flow rate control slider on the pump body. Moving the switch towards

“+/Max.” will increase the flow rate and moving it towards “-/Min” will decrease it. On some types

of pumps, flow regulator may be turned clockwise or counterclockwise to adjust.