Instructions / Assembly

www.encloscreens.com
ASSEMBLY INSTRUCTIONSEC18005
6
1. Slide the notch of the Floor Supports (D) over the inside
wall of the routed section of the long boards.
2. Place the Floor Board (C) inside the planter box until it
rests on the oor supports.
(Optionally)
3. If your planter box will be outside, it is recommended
to drill (2) ¾" diameter holes through the oor board for
water drainage.
1. Slide the Side Boards (A) between the two assembled planter sections.
2. Drive (4) 2½" self-drilling stainless steel screws through the pre-drilled
holes on the inside face of the posts to secure the side boards.
STEP 2.3
STEP 2.4
1
1
2
2
D
Ensure that the side
boards are touching
the back of the post
channels.
Align the notch with
the inside wall of the
routed section.
C
A