Installation & Assembly

www.encloscreens.com
6
ASSEMBLY INSTRUCTIONSZP19036
STEP 3.1
STEP 3: ASSEMBLE FENCE PANEL
b One by one, guide the
numbered Pickets (E) through
the top and middle rails until
the pickets lock into place in
the bottom rail.
G
STEP 3.1
Note: If your
ground is very hard,
the anchor can be
slid until the bottom
of the anchor is 8”
beyond the bottom
of the posts.
Pickets 1,2,3, etc...
1. Slide the bottom rail over the post, aligning the
pre-drilled holes on the bottom rail with the holes
on the post.
2. Insert the Post Anchors (G) 6" into the bottom of
the post. 10" of post anchor should be visible.
3. Use the 1/8" Drill Bit (K) to drill (4) total holes in
the post anchor through the pre-drilled holes in
the bottom rail.
4. Drive (4) 3/4" self-drilling stainless steel screws
into the pre-drilled holes in the bottom rail.
1
2
4
3
5
678
7
4
3
5
6
1
2