Installation Guide

FPTS6-FIREPLACE TOOL RACK

Enclosed you will find everything needed for the assembly

and use of your fireplace tool set.

Hardware included:

6- 3/8 x 16 x 5/8 Buttonhead Screws

3- Hard Glides

1-7/32 Hex Key

Components included:

3- Upright Legs

3- Bottom Angled Brackets

3- Top Angled Bracket

1- Broom

1- Shovel

1 - Poker

See reverse side for ASSEMBLY AND INSTALLATION INSTRUCTIONS

Thank you for choosing Enclume!

Enclume racks are the ultimate quality,

design, strength and function.

WARNING: READ ALL OF THE

INSTRUCTIONS BEFORE

ASSEMBLING AND USING YOUR

RACK

If you need help, please call 1-877-ENCLUME

Enclume Design Products

24 Colwell Street, Port Hadlock, WA 98339

Phone 360-385-6100  Fax 360-385-6156

www.enclume.com

PAGE 1
FPTS6-FIREPLACE TOOL RACK Thank you for choosing Enclume! Enclume racks are the ultimate quality, design, strength and function. WARNING: READ ALL OF THE INSTRUCTIONS BEFORE ASSEMBLING AND USING YOUR RACK If you need help, please call 1-877-ENCLUME Enclume Design Products 24 Colwell Street, Port Hadlock, WA 98339 Phone 360-385-6100  Fax 360-385-6156 www.enclume.com Enclosed you will find everything needed for the assembly and use of your fireplace tool set.
PAGE 2
Instructions for Assembling Rack Assembly 1) Using a 5/8" buttonhead screw, secure two of the top angle brackets to the upright legs by positioning the brackets so that the notch is on top. Place one bracket on each side of the upright leg. Then insert the buttonhead through the large hole on the top angle bracket, the hole in the upright leg and screw into the threaded hole in the other top angle bracket. Do not tighten fully at this point.