Installation & Assembly

Corner Stand (Unassembled)

CS4KD

If you need assistance, please call 1-877-ENCLUME

Enclume Design Products

24 Colwell Street, Port Hadlock, WA 98339

Enclosed you will find everything needed for the assembly and use of your storage rack. Two people make

assembly easier.

Hardware included:

16 – 5/16" x 1/2" Button Head Screws

1 – Hex key

Components included:

1 – Angled Corner Upright

2 – Straight Uprights

1 – 2" Wide Corner Shelf Rim (Base)

3 – 1" Wide Corner Shelf Rims

4 – Wood Shelves

ASSEMBLY INSTRUCTIONS

Lay out the components and hardware.

Working on the floor, take the upright with the angled corner and attach the 2" wide corner shelf rim to

the bottom (that is the base of the stand) of the stand with two of the button head screws. Then attach a

1" shelf rim at the top of the upright. Attach the remaining two 1" center shelf rims to the upright. Leave

screws a little loose.

3) After all shelf rims are attached to the first upright, rotate the stand and attach the next upright to all 4 shelf

rims. Rotate once again to attach the 3

and final upright. Remove the protective ends from both ends of all 3

uprights. Leave screws a little loose.

4) After standing it in an upright position, square up your stand and tighten your screws. You may place the wood

shelves on the shelf rims.

5) That’s it! You are now ready to enjoy your new stand.

WARNING: It is important that your fireplace tool stand is assembled correctly. If the unit is assembled or used incorrectly, it

could become unstable and collapse, possibly causing injury.

LIMITED WARRANTY: This product is warranted to be free of material defects, other than that from normal use, for a period of

five years from the date of purchase. Customer's exclusive remedy shall be the repair or replacement of the defective product

and shall be subject to the following conditions: (1) notice of any defect is received by Enclume within the warranty period and

(2) customer returns the defective product to Enclume Design Products, 24 Colwell St., Port Hadlock, WA 98339, postage

prepaid within 20 days following a return authorization number (which may be obtained by telephoning the number at the top

of this instructions) being provided to the customer by Enclume. There are no other warranties, expressed or implied. THERE

ARE NO WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE. ENCLUME SPECIFICALLY DISCLAIMS

ANY AND ALL INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING OUT OF THE PURCHASE OR USE OF ENCLUME'S

PRODUCTS.