Installation Guide

ASSEMBLY INSTRUCTIONS
Rack Assembly:
1) Align one of the two rectangle body pieces with one of the legs. Place one of the lower support bars on top of
the rectangle body. Thread one 5/8" button head through the support bar and through the rectangle body
screwing into the threaded leg hole. Tighten only finger tight.
2) Repeat with the other support bar and then the other body for the other side.
3) Join the top of the two rectangle body pieces with the upper support bar. Place the support bar under the body
pieces and using 3/8" button head screws from the top of the body through the rectangle body pieces into the
upper support bar.
4) Square up your new log rack and tighten all the screws firmly.
It is important that your rack is assembled correctly. If the unit is assembled or
used incorrectly, it could become unstable and collapse, possibly causing injury
WARNING
Limited Warranty: This product is warranted to be free of material defects for a period of five years from the date of purchase. Your exclusive remedy is the
repair or replacement of the defective product, which shall be subject to the following conditions: (1) notice of any defect is received by Enclume within the
warranty period and (2) you return the defective product to Enclume Design Products, 24 Colwell St., Port Hadlock, WA 98339, postage prepaid, within 20 days
following your receipt of a return authorization number from Enclume (which may be obtained by telephoning the number at the top of this instruction). There are
no other warranties, expressed or implied. THERE ARE NO WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
ENCLUME SPECIFICALLY DISCLAIMS ANY AND ALL INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING OUT OF THE PURCHASE
OR USE OF THIS PRODUCT.