Full Product Manual

PR15-WALL DOME

Enclosed you will find everything needed for the assembly

and use of your storage rack. Two people make assembly

and installation easier. The parts and hardware included are:

Hardware included:

3 –3/8” x ½” Button Head Screw

2 – 2” Lag Screw

Toggler® Kit

1 – 7/32” Allen Wrench

2 - 1 ½" Wood Screws

Components included:

1 – Half Round Base

3 – Arms

1 – Back Bar

1 – D-ring Axial

6 – Angled Pot Hooks

6 – Straight Pot Hooks

See reverse side for ASSEMBLY AND INSTALLATION INSTRUCTIONS

1 1/2” Wood Screw

Thank you for choosing Enclume!

Enclume racks are the ultimate in

quality, design, strength and function.

WARNING: READ ALL OF THE

INSTRUCTIONS BEFORE

ASSEMBLING AND USING YOUR

RACK

If you need help, please call 1-877-ENCLUME

Enclume Design Products

24 Colwell Street, Port Hadlock, WA 98339

Phone 360-385-6100  Fax 360-385-6156

www.enclume.com

PAGE 1
PR15-WALL DOME Thank you for choosing Enclume! Enclume racks are the ultimate in quality, design, strength and function. WARNING: READ ALL OF THE INSTRUCTIONS BEFORE ASSEMBLING AND USING YOUR RACK If you need help, please call 1-877-ENCLUME Enclume Design Products 24 Colwell Street, Port Hadlock, WA 98339 Phone 360-385-6100  Fax 360-385-6156 www.enclume.com Enclosed you will find everything needed for the assembly and use of your storage rack. Two people make assembly and installation easier.
PAGE 2
1 ½” Wood Screws ASSEMBLY AND INSTALLATION INSTRUCTIONS Rack Assembly 1) If your rack is plated it is best to keep the tissue on during installation to avoid fingerprinting. 2) Thread the D-ring through the roll at the top if each of the three arms. 3) Fasten the arms to the outside of the half round base with the three button head screws. Tighten the screws. 4) Hold the rack up to the wall, carefully measure and mark the wall. The base must go into the solid wood of wall studs or into a wooden wall.