Operations Guide

Intelligent Electronic swing handle – User operations
guide
Rev.1.0 11
Rear Door
1. The network connection for the rear door is the same as the front door.
2. Ensure the network cable has slack on the hinge side of the door so that it does not get pinched.
3. Connect the RED Network cable to the RJ45 Sensor Port on either the IPDU or sensor POD
Door Switch Sensor
1. The Door Switch Sensor consists of two parts:
● 1.2m cable to 5pin connector with Door switch sensor
● Magnet
2. Plug the 5pin connector into the back of the Smart-handle.
3. Route and attach the 1.2m cable to the inside of the door and attach the switch sensor to the door
using a dual adhesive pad or screws. In most instances the best location is near the top of the door on
the handle side.
4. Close the door and locate the position on the frame inside the rack that corresponds to the location of
the switch sensor.
5. Open the door and attach the Magnet to the frame in the location identified using a dual adhesive
pad or M3 tapping screws.