Installation manual

E9 IN REV. A

RED WIRE — SYSTEM POWER (+12V CONSTANT) —

The RED wire supplies power to the system. Connect this wire to a stable constant +12 volt source.

H5. 3-PIN BLACK CONNECTOR. – TWO-WAY TRANSCEIVER/ANTENNA MODULE

The Two-way transceiver/antenna mounting location

should be the upper left or lower left corner of

driver’s windshield. For optimum range we

suggest that the antenna be mounted Antenna

tip facing down.

Warning!

Do not mount in such a manner that it obstructs the

driver’s view.

- Remove the protective tape backing.

- Carefully align the two-way transceiver/antenna and apply to windshield.

- Route the black connector wire behind the trim and connect to the two-way transceiver/antenna.

- Connect the other end to the control module.

- Special considerations must be made for windshield glass as some newer vehicles utilize a

metal-shielded window glass that will inhibit or restrict RF reception. In these vehicles, route the two ways

transceiver/antenna module away from metallic shielded window glass as far as possible.

2 PIN BLUE CONNECTOR FOR THE VALET SWITCH:

Select a mounting location for the switch that is easily accessible to the driver of the vehicle. The switch

does not have to be concealed, however, concealing the switch is always recommended, as this

provides an even higher level of security to the vehicle. Mount the valet switch in a hidden but

accessible location. Route the valet switch wires to the control module.

4 PIN ORANGE CONNECTOR 2 STAGE SHOCK SENSOR (ZONE 1 / 4)

1. Green Wire / Zone 1 Warn Away Input

2. Blue Wire / Zone 4 Ground Trigger

3. Black

Wire / Ground

4. Red Wire / +12Volts

22 PIN WIRE CONNECTORS:

BROWN/BLACK WIRE: 200 mA (-) Ground Output When Running.

This wire provides a negative output during the remote start process. It can be used to operate by-pass

modules that may be required in your installation. This wire will provide ground once the remote start process

has been initiated and will remain grounded while the engine is running

Blue/Black wire – (-) 200mA Accessory 2 Output –

This wire provides a 200mA (-) ground output. This output will energize when the remote start is activated, go away

while the starter is cranking, and then come back on when the vehicle has started successfully.