Cleaning Instructions

25Cleaning Instructions for Burner, Pilot Assembly, and Emitter Screen • Series: 220000-450000

For assistance call: 1.800.762.1142

Step 29 – 30

29. Check burner connections:

1. Make sure the regulator valve and hose connections are securely fastened to the

burner and the tank.

2. If your unit was assembled for you, visually check the connection between the

venturi tube and orifice. Make sure the venturi tube fits over the orifice.

W WARNING: Failure to inspect this connection or follow these instructions

could cause a fire or an explosion which can cause death, serious bodily

injury, or damage to property.

3. If the burner pipe does not rest flush to the orifice, please contact 1.800.762.1142

for assistance.

30. Tank/Gas Line Connection

1. Make 2-3 oz. of leak solution by mixing one part liquid dishwashing soap with

three parts water.

2. Make sure control knob is in “OFF” position. (Figure 3)

3. Turn LP gas tank valve to “OPEN”.

4. Spoon leak check solution at all “X” locations. (Figures 1 and 2)

a. If any bubbles appear turn LP gas tank valve to “CLOSED”, reconnect and re-

test.

b. If you continue to see bubbles after several attempts, turn LP gas tank valve

to “CLOSED”, disconnect LP gas tank and contact 1.800.762.1142 for

assistance.

c. If no bubbles appear after one minute turn LP gas tank valve to “CLOSED”,

wipe away solution and proceed.

Figure 1

Figure 2

Figure 3

PILOT / VEILLEUSE

push in / pressez et maintenez

LOW /

BAS

HIGH /

HAUT

OFF /

ARRÊT