User Manual

Light Off

Out of battery. Return to Docking Station.

Docking Station Visual Cues

Light

Event/Required Action

Flashing White

The Reader is being charged.

Solid White

The Reader is fully charged and ready for use.

No Light

When the Reader is docked and no light is

present, the Docking Station is not connected to

a power source. Check that the Docking Station

Power Cord is plugged into both Docking Station

and electrical outlet. If the light remains off,

contact customer service. To turn off audio and

visual cues from the Reader during this time,

put the Reader into Travel Mode (see Traveling

with the myCordella System below).

Traveling with the myCordella Patient Reader and

Docking Station

myCordella PA Sensor System is designed to be portable and should

be taken with you on personal or business travel. Endotronix®

recommends carefully packing the Patient Reader in a carry-on

suitcase by wrapping the Reader in bubble wrap or clothing and

storing in the center of the suitcase. The Docking Station and power

cord should be wrapped separately and also be stored in a suitcase

where it will be under the least amount of stress.

To travel with the Reader, remove the Reader from the Docking

Station and press and hold the travel button on the Reader for several

seconds to initiate Travel Mode. The travel button is a small button

located on the bottom of the Reader, at the base of the handle and

adjacent to the power connector. Depressing the button will disable

the audio and visual cues on the Reader and prevent damage to the

batteries. This same process can be used to Power Off the Reader at

any time. To restart the Reader after travel, press and hold the button

again. If you are unable to charge the Reader during your travels

continue taking your scheduled readings by restarting the Reader,

taking a reading, and powering the Reader back off.