Installation Instructions
Table Of Contents
- Table of contents
- About this document
- Function and system design
- Input (wired interface)
- Output (wireless interface)
- Power supply
- Installation
- Environment
- Mechanical construction
- Human interface
- Certificates and approvals
- Ordering information
- Accessories
- Supplementary documentation
- Registered trademarks
- Radio approvals
FieldPort SWA50
18 Endress+Hauser
Standard documentation for
SWG70
Technical Information
TI00027S
Operating Instructions
BA00064S
Registered trademarks
Bluetooth®
Registered trademark of the Bluetooth Special Interest Group (SIG), Kirkland, Washington, USA
HART®
Registered trademark of the FieldComm Group, Austin, Texas, USA
WirelessHART ®
Registered trademark of the FieldComm Group, Austin, Texas, USA
Radio approvals
Europe
This device meets the requirements of the "Radio Equipment Directive" (RED) 2014/53/EU:
• EN 300 328 V2.1.1
• EN 301 489-1 V2.1.1
• EN 301 489-17 V3.1.1
• EN 62311: 2008
Canada and United States
FCC ID: LCGSWA5
IC: 2519A-SWA50
This device complies with Part 15 of the FCC Rules and with Industry Canada license-exempt RSS
standard(s).
Operation is subject to the following two conditions:
• this device may not cause harmful interference, and
• this device must accept any interference received, including interference that may cause undesired
operation.
Changes or modifications made to this equipment not expressly approved by
Endress+Hauser SE+Co. KG may void the FCC authorization to operate this equipment.
This device has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
• reorient or relocate the receiving antenna
• increase the separation between the equipment and receiver
• connect the equipment into an outlet on a circuit different from that to which the receiver is
connected
• consult the dealer or an experienced radio/TV technician for help with radiofrequency radiation
exposure information.
This equipment complies with FCC and IC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with a minimum distance of 20 cm
(7.87 in) between the radiator and your body.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.