Installation Instructions

FieldPort SWA50
6 Endress+Hauser
WirelessHART
• WirelessHART communication interface (IEC 62591)
• HART version 7.5, backward-compatible with previous HART versions
Transmission frequency
band
2.4 GHz (ISM band)
Range
The range depends on the alignment of the FieldPort SWA50, the mounting location and the
environmental conditions.
100°60°
A0043409
 3 Range of opening angle
Bluetooth
Up to 40 m without obstacles when FieldPort SWA50 is optimally aligned
WirelessHART
Up to 200 m without obstacles when FieldPort SWA50 is optimally aligned
Transmission power
0 dBm or 10 dBm, configurable for adaptation to national regulations
Device variables
You can read out the following data via Bluetooth® using the Endress+Hauser SmartBlue app or
the Field Xpert:
For all HART field devices:
• Measured value output current of HART field device
• Device information, configuration data and HART information of FieldPort SWA50
Also for Endress+Hauser HART field devices:
• Measured values PV, SV, TV and QV of HART field device
• Additional device information of HART-7- or HART-6 field device
• HART information of HART field device
• Status as per NAMUR NE 107 of HART field device if available
The HART field device must be connected.
The following data can be read out via the Bluetooth version of the FieldPort SWA50 and the
Endress+Hauser FieldEdge SGC200(Netilion Cloud):
• Process variables PV and SV of HART field device if available
• Status as per NAMUR NE 107 of HART field device if available
The HART field device must be connected.
For the WirelssHART version of the FieldPort SWA50 and the Endress+Hauser
FieldEdge SGC500(Netilion Cloud)
For detailed information, see the Operating Instructions for the FieldPort SWA50
WirelessHART→  17
Diagnostics
1 LED
Green: Flashes twice at start-up to indicate that the device is operational
The LED is located on the electronic insert and is not visible from the outside.