User's Manual
Table Of Contents
- Application
- Your benefits
- Table of contents
- Applications
- Communication interface
- Function and system design
- Measuring system
- Configuration with analogue input 4...20 mA (FXA320 only)
- Configuration with binary input (FXA320 only)
- HART - Point-to-Point configuration (FXA520 only)
- Configuration with analogue input 4...20 mA (FXA520 only)
- HART Multiplexer configuration (FXA520 only)
- HART - Multidrop configuration (FXA520 only)
- All E+H measuring devices with the HART protocol can, therefore, be used to the full extent with ...
- Measuring system
- Input
- Output
- Power supply
- Operating conditions: Installation
- Installation instructions
- Operating conditions: Environment
- Mechanical construction
- Human interface
- Certificates and approvals
- Telecommunications Regulatory Compliance
- Ordering information
- Accessories
- Documentation
Fieldgate FXA320, FXA520
22 Endress + Hauser
Telecommunications Regulatory Compliance
Fieldgate analogue version North America
FCC CFR 47, part 15 and part 68
Europe
Telecoms Terminal Equipment Directive (98/13/EG)
European approval TBR 21
Fieldgate GSM version North America
FCC CFR 47 Part 15 and Part 24
Federal Communications Commission Notice
This device generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the device off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
To ensure that the unit complies with current FCC regulations and safety requirements limiting both maximum
RF output power and human exposure to radio frequency radiation, use an antennna with a maximum gain of
2dBi and a separation distance of at least 20 cm must be maintained between the unit's antenna and the body
of the user and any nearby persons at all times and in all applications and uses.
Modifications
The FCC requires the user to be notified that any changes or modifications made to this device that are not
expressly approved by Endress+Hauser may void the user's authority to operate the equipment.
Federal Communications Commission Statement
FCC-ID: LCG-FG-FXA52x-32x
This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation.
Wireless Notices
In some situations or environments, the use of wireless devices may be restricted. Such restrictions may apply
aboard airplanes, in vehicles, in hospitals, near explosives, in hazardous locations, etc. If you are uncertain of
the policy that applies to the use of this device, please ask for authorization to use it prior to turning it on.