MSDS

10. STABILITY AND REACTIVITY
CHEMICAL STABILITY (CONDITIONS TO AVOID): This material is considered stable.
INCOMPATIBILITY: Not established
HAZARDOUS DECOMPOSITION PRODUCTS: Thermal decomposition may yield carbon dioxide carbon monoxide.
HAZARDOUS POLYMERIZATION: Product will not undergo polymerization.
11. TOXICOLOGICAL INFORMATION
None known.
12. ECOLOGICAL INFORMATION
ECOTOXICOLOGICAL INFORMATION: No applicable data.
CHEMICAL FATE INFORMATION: No applicable data.
13. DISPOSAL CONSIDERATIONS
Dispose of in accordance with all Local, State and Federal waste disposal regulations.
14. TRANSPORT INFORMATION:
NOT MEANT TO BE ALL INCLUSIVE
US DOT Hazard Class............Non hazardous
15. REGULATORY INFORMATION:
NOT MEANT TO BE ALL INCLUSIVE - SELECTED REGULATIONS REPRESENTED
U.S. FEDERAL REGULATIONS: The components of this product are included on the TSCA inventory.
OSHA: Non hazardous
CERCLA: SARA HAZARD CATEGORY: Release of this material to air, land, or water are not reportable to the National
Response Center under the Comprehensive Environmental Response, Compensation, and Liability Act (CERCLA) or to state and
local emergency planning committees under the Superfund Amendments and Reauthorization Act (SARA) Title III Section 304.
SECTION 313: * Indicates toxic chemical(s) subject to the reporting requirements of section 313 of Title III and of 40 CFR 372.
INTERNATIONAL REGULATIONS:
CANADIAN WHMIS: Not Determined.
CANADIAN ENVIRONMENTAL PROTECTION ACT (CEPA): All components of this product are on the Domestic Substances
List (DSL), and acceptable for use under the provisions of CEPA.
EINECS: All the components of this product are on the European Inventory of Existing Commercial Chemical Substances.
STATE REGULATIONS:
VOLATILE ORGANIC COMPOUNDS: The Volatile Organic Compounds (VOCs) are below the emission limits as regulated by
The Environmental Protection Agency (EPA) and state regulations.
16. OTHER INFORMATION
NAME OF PREPARER: Jim Stanley
REVISION DATE: September 3, 2008
HMIS CODES: H F R P
0 0 0 0
HMIS HAZARD RATINGS: H=HEALTH, F=FIRE, R=REACTIVITY, P=PERSONAL
SCALE: 0=MINIMAL, 1=SLIGHT, 2=MODERATE, 3=SERIOUS, 4=SEVERE
PERSONAL PROTECTION: See Section 8, Exposure Controls/Personal Protection for recommended handling of material as
supplied; check with supervisor for your actual use condition.
HMIS is a registered trademark of the National Paint and Coatings Association.
LIST OF ACRONYMS:
ACGIH: American Conference of Government Industrial Hygienists
IARC: International Agency for Research on Cancer
NTP: National Toxicology Program
OSHA: Occupational Safety and Health Administration
PEL: Permissible Exposure Limit
PPM: Parts Per Million
SARA: Superfund Amendment Reauthorization Act
TLV: Threshold Limit Value
TSCA: Toxic Substance Control Act
Please note that this MSDS applies to industrial handling of this material. Consumers should read product label. The information
and recommendations set forth herein are believed to be accurate, The data is derived from information provided to Custom
Chemical Consultants. from its raw material suppliers. Custom Chemical Consultants makes no guarantee or warranty, expressed
or implied, regarding the accuracy, reliability, or completeness of the data or the results to be obtained from the use thereof. It is
the responsibility of the user of the product to comply with all applicable federal, state, and local laws and regulations.