Product Manual

Page 2
Reverse motor leads
here to change rotation
8 to 6 Awg wire
depending on
distance
Capstan
Clockwise
Capstan
Counter Clockwise
Load Pull
WARRANTY: LIMITED WARRANTY Endurance Marine warrants all parts and components to be free from defects in materials and
workmanship for a period of one year from the provable date of purchase. Any Endurance product which is defective will be repaired or replaced
without charge to the Buyer, upon compliance with these procedures.
1. Position the Capstan and determine
which direction the load will be pulled
(from the left (1) or right (2)). This will
determine the rotation of the Capstan
for Clockwise (CW) (Load pull from left)
or Counter clockwise (CCW). You may
have to switch the wires on the solenoid
to get the right direction.
2. Splice the heavy gauge leads to the
motor pigtails. Use marine grade
insulated compression connectors and
tape.
3. Mount the solenoid and the circuit
breaker in a dry accessible location,
preferably in a water tight box.
4. The circuit breaker assembly must be
installed between the battery positive
terminal and the positive wire.
5. NOTE: Make the positive connection to
the battery last. Do not connect
components to ground, especially on an
aluminum boat.