Product Manual

Endurance Marine Products Ltd.

210-19138 26 ave

Surrey, BC V3S 3V7

Phone: 604-535 0669

Fax: 604-535-0681

Toll free: 877 535 0669

Email: info@endurance-marine.com

www.endurance-marine.com

Endurance Marine

Products Ltd.

Notice

Limited Motor Warranty

MOTOR – The power train is provided by a 1.5 horsepower DC 12 Volt motor

and a dual carriage, six planetary gear system with a 121 to 1 gear ratio. These

gears make a substantial noise (approx. 80db) when running. NOTE: (this

noise is normal and there is nothing wrong with your winch.) These gears are

sealed and do not require maintenance. The direction that the motor turns may

be reversed by changing the polarity. Simply connect the battery wire leads the

opposite way, to run the motor in the opposite direction. The motor has a steel

housing which is subject to corrosion. Should the paint become scratched it

should be spray painted to prevent further rusting. NOTE: The motor will draw

up to 60 amps under large loads. We provide an 80 amp breaker which we

recommend be connected between the battery and motor. When operating the

WINCH, the boat motor should be running to provide adequate charge to the

system’s battery.

· This 1.5 hp DC motor has been specifically engineered to provide a longer than

normal duty cycle.

· This type of motor produces heat when operating.

· The maximum operating cycle under minimum load is 10 minutes.

· The maximum operating cycle under maximum load is 5 minutes.

· When operated for any longer periods the operator must periodically feel the

motor casing for heat buildup.

· In the event of overheating, allow the motor to cool for 5 minutes prior to

reusing.

The 80 amp thermal breaker (provided) must be installed on the positive

terminal as close to the battery as possible.

The polarity may be reversed to change the direction of rotation.

OVER HEATING WILL VOID THE WARRANTY

PAGE 1
Endurance Marine Products Ltd. Notice Limited Motor Warranty MOTOR – The power train is provided by a 1.5 horsepower DC 12 Volt motor and a dual carriage, six planetary gear system with a 121 to 1 gear ratio. These gears make a substantial noise (approx. 80db) when running. NOTE: (this noise is normal and there is nothing wrong with your winch.) These gears are sealed and do not require maintenance. The direction that the motor turns may be reversed by changing the polarity.
PAGE 2
Installation Instructions Windlass Model WCH800 Horizontal Mount CONTENTS IN PACKAGE WCH800 WINDLASS Circuit breaker assembly with bracket, nut, and bolt 12 volt DC solenoid 100amp Deck foot switch package REQUIRED TO PURCHASE 1. 4-5/16” (8mm) stainless steel flat head bolts. (length to be determined by deck thickness). 2. 4-5/16” (8mm) nuts and washers. 3. 18 ga insulated wire, length as required between the solenoid and deck foot switch. 4. 1-1/4” hole saw. 5.
PAGE 3
Capstan Clockwise Capstan Counter Clockwise Load Pull Reverse motor leads here to change rotation 1. Position the Capstan and determine which direction the load will be pulled (from the left (1) or right (2)). This will determine the rotation of the Capstan for Clockwise (CW) (Load pull from left) or Counter clockwise (CCW). You may have to switch the wires on the solenoid to get the right direction. 2. Splice the heavy gauge leads to the motor pigtails.