Operating Guide

Page 11

WALK-IN TUB MANUAL

INSTALLATION INSTRUCTIONS

CONNECTING THE AUTODRAIN

HIGH-SPEED AUTODRAIN FOR SOAKING TUB AND/OR AIR SYSTEM

• Drain System requires the connection to a minimum 1 ½ sanitary drain line.

• Use UPC Approved PVC Glue, primer, and Schedule 40 1 ½ ’ pipe.

• Do not change or modify the location and or piping of the Back Flow Preventer.

• The sanitary tee is installed directly above the drain tee with clearance not greater than 1’’.

• Dry fit the drain overflow assembly to the sanitary drainage pipe and check for proper fit.

• Glue the High-Speed Autodrain Fittings, pipe and drain overflow assembly to the sanitary drainage pipe.

• NOTE: WATER TIGHT INSTALLATION OF THE WASTE/ OVERFLOW IS THE INSTALLER’S RESPONSIBILITY. DRAIN LEAKAGE

IS EXCLUDED FROM MEDITUB WARRANTY OF THIS PRODUCT.

NOTE: WE HAVE TAKEN RESPONSIBLE PRECAUTIONS TO ENSURE THE HIGH-SPEED AUTODRAIN IS SUITABLE FOR

RESIDENTIAL PLUMBING. IT IS RESPONSIBILITY OF THE INSTALLER TO INSURE THE SANITARY SYSTEM IS ACCEPTABLE

FOR THE USE OF THE HIGH-SPEED AUTODRAIN. WE DO NOT ACCEPT RESPONSIBILITY FOR DAMAGE ARISING FROM THE

USE OF THE HIGH- SPEED AUTODRAIN.*

*-Ensure compliance with local plumbing codes.

110Vt-60hz pump (15 Amp Circuit)

overflow

drain cable

drain

drain shoe

sanitary tee

drain tee

90° Elbow

reducer 1 1/2-1”

air button (on/off)

back flow preventer