Operating Guide

Page 19
WALK-IN TUB MANUAL
operating instructions
CLEANING AND MAINTENANCE
Pump and pipe circulation systems should be flushed before first use and on a monthly basis when product is under normal use.
Below are the recommended procedures for cleaning:
• Donotrunwhirlpooldry.Fillthetubwithhotwater2-3inchesabovethejetsandadd2-3teaspoonsoflowfoaming
detergent such as dishwashing machine detergent
• Turnonwhirlpoolsystemandrunfor10minutes
• Draintubcompletely
• Filltubwithcoldwaterabovejets
• Turnonwhirlpoolsystemandrunfor15minutes
• Draintubcompletely
• Cleaningthesuctioncover:Cleanandremoveanyhairorlintfromthesuctioncover(seeimagebelow).Onamonthlybasis,
unscrew the suction cover and clean away any hair, lint or debris from the cover and housing, then remount the cover in place. Some
suctions are not designed to be removed; only suctions that have screws on the cover, visible from the inside of the tub, can be
removed.
WARNING! NEVER OPERATE THE UNIT WITH THE SAFETY SUCTION COVER OFF.
SUCTION COVER