Installation Guide

Page 14
WALK-IN TUB MANUAL
INSTALLATION INSTRUCTIONS
INSTALLATION INSTRUCTIONS
5701 NW 35 Avenue Miami, FL 33142 • Phone [phone] • Fax [phone]
DOOR DRAIN CONNECTION
Your walk-in tub also has a door drain to remove excess water from the door after each use.
1. From the underside of the unit, a hose is connected to the door drain with a check valve. This hose and valve is to provide a one-
way flow from the door drain to the main drain pipe. The check valve will constrict the water flow away from the door.
2. Insert the opposite end of the hose into the port on the main drain. Be sure the port is open before attaching the hose. Secure
the hose with clamps or ties.
3. Once the hose is in place, close the door on the unit, place the handle in the locked position, and fill tub with at least 12” of water
to test the connection.
4. Once the completion of the drain components are installed and have been tested for proper function, the unit can be leveled and
give a final water test before installation of unit (Figure 4).
FIGURE 4
Overflow Pipe
Sanitary
Tee
Flow
Connect door drain to
floor drain pipe from
about a 45° angle.
Do not connect from
directly above because
it may hinder flow.
Do not connect from below
45° as water will fall back
into the door drain tube.
Check Valve
Door Drain
Connection Pipe
Flow
Floor Drain
Door Drain
Walk-in Bathtub