Installation Guide

Page 10

WALK-IN TUB MANUAL

OPERATING INSTRUCTIONS

5701 NW 35 Avenue Miami, FL 33142 • Phone 866-633-4882 • Fax 866-560-1060

INSTALLATION PROCEDURES

WARNING! WHEN INSTALLING A JETTED WALK-IN BATHTUB, THE FOLLOWING BASIC

PRECAUTIONS SHOULD BE FOLLOWED.

DANGER! RISK OF ELECTRIC SHOCK. CONNECT ONLY TO SEPARATE CIRCUIT PROTECTED BY A

GROUND FAULT CIRCUIT INTERRUPTER (GFCI) ON PLUG IN UNITS.

NOTE: INSTALLATION MUST PROVIDE ACCESS FOR SERVICING PUMP/MOTOR (ALL TUBS COME WITH AN ACCESS PANEL

FOR THE PUMP/MOTOR).

GENERAL GUIDE-THROUGH

• Install tub waste/overflow according to instructions (see page 11).

• After framing is a complete (see attached diagrams), set product in place to make certain the tub can be

properly leveled. (Caution: If a walk-in bathtub is not resting on all leveling feet, water will not drain properly

and may cause the door to leak) (see page 8).

• Verify the product’s level by checking tub’s deck surface and ensure all leveling feet are touching the

ground (see page 8).

• Electrical connection is made pre-instruction on specified models.

• After plumbing and electrical connections have been made, the tub should be cleaned of dirt and debris.

• Installation is not complete until the tub has been tested in place.