Operation Manual

ENDURO

LI1220 15

Ref: LI1220-UM-TKI-0115-Rev.A

 Do not discharge the battery while the battery is charging.

 Do not expose the battery/charger to harsh chemicals.

 Keep the battery/charger away from children and animals.

 Do not expose the battery/charger to flame or other high heat sources.

 Charge battery regularly.

 It is important to maintain at least 25% of your battery power when not in use.

 Do not expose the battery/charger in a place with heat or with direct sunshine.

 The chemical reaction during charging and discharging a LiFePO

battery is not fully

reversible. Due to that, LiFePO

batteries loose capacity during their life-span. This is

normal and not a manufacturing nor production fault.

INSTALLATION

FOR PROFESSIONAL INSTALLATION ONLY. These instructions are for

general guidance. Installation procedures may vary depending on your

situation

The LI1220 battery should not be used or installed by people, who don’t

have experience or knowledge how to use it. The user must have enough

competency to install it. Otherwise he must ask for help by qualified

personnel.

Unpack all the components and check for the presence of all parts (see package contents

list). Make sure the goods meet your requirement.

Check if the battery or charger isn’t damaged during the transport.

The charger and the battery should be put in indoor environment with good ventilation

and good cooling system. Do not expose to humid, high temperature, flammable,

explosive gas environments.

Find a suitable place for LI1220 battery and charger such as a storage area, under a seat

or a bed. Make sure there is sufficient ventilation all around. A space of at least 10cm

should be allowed.

Make sure that the battery and/or charger cannot be completely covered

by cloths or other isolation materials!

Mount the two belt brackets with small screws (not supplied)

on the ground, next to the battery housing (Nr. 1, on both

sides) and fix the battery securely into position with the

supplied strap. Make sure that the belt is also routed via the

strap-sleeves of the battery (Nr. 2, on both sides)

At the output terminals of the battery, the plus and minus

cables can be fixed with the supplied M8 washers and screws.