Specifications

ManualsBrandsEneo ManualsHome building and DecorFastrax III EDC-3182

Follow steps below to store the Preset positions:

1. Press the

PRST key to enter the preset menu directly. Or press the MENU key to display the main menu on the monitor. Scroll to preset and push the

Joystick to the right.

2. Select the blank preset position to be stored by pushing the

Joystick up, down, right, or left.

3. After selecting a blank position, press and hold

CTRL. Use the Joystick to control the direction of the camera and lens.

4. After aiming the camera (view direction and lens control), release

CTRL. The cursor will be on the Title then twist the Joystick handle or Press Tele or

Wide Key to edit the preset title. Follow the procedure of the auto scan above to edit titles.

5. Select „CAMERA SET” and pushing the

Joystick left or right. Then the preset camera setup displays.

Set FOCUS: AUTO, MANUAL, ONE PUSH

Select „AE SETUP” and pushing the

Joystick left or right. Then the AE setup displays. Refer to the AE SETUP in the camera setup.

6. Set „DWELL TIME”(03-99seconds)

7. To select the next page of presets, scroll the page by pushing the

Joystick to the Left on the ﬁrst and last columns of the menu.

8. Repeat steps 2 through 7 for each additional preset position.

9. Select SAVE AND EXIT by pushing the

Joystick to the right. Press ESC to exit the Preset menu without saving.

NOTE: Press the HOME key at programmed preset position (*) to delete a programmed preset view.

The position, which is marked with *, already has the preset view assigned. To review the stored preset, press PRST key on the *. The camera will show the

stored preset scene.

PRESET AREA SETUP

(CTRL KEY)

NUMBER 001

PAN TILT

000.0 000.0

EXIT (ESC TO EXIT)

Hold down the CTRL key while selecting the desired scene using the Joystick. Current position will be displayed. Release CTRL key to complete. Or Press

IRIS OPEN then the „CTRL” displays. Move the desired position and the zoom position. Press IRIS CLOSE then the „CTRL” disappears. Select Exit and push

the Joystick to the right. Follow steps above to save the preset.

3.6 Shortcut of Preset Program

After selecting the desired scene, press No. (1 to 240), and press CTRL and PRST subsequently. The current view will be stored to the selected preset

number if the preset number is empty. If selected preset number is not empty, „OVER WRITE” message will be displayed on the monitor and select the „OK”

and push the Joystick to the right to overwrite.

Example: 1 , 0 , 1 + CTRL + PRST will store current view as preset No. 101. In this case, focus will be programmed as Auto, dwell time will be set to

3 seconds, and the current AE mode will be programmed.

PRESET CAMERA SETUP

FOCUS: AUTO

AE SETUP

SAVE AND EXIT (ESC TO EXIT)