User manual

27
RESOLUTIO
N
Set the resolution for the specified channel: 1920x1080, 1920x540, 1280x720 and
640x360. You can see the 1920x1080 and 1920x540 menu when 2M HD-SDI camera is
connected.
FRAME
RATE
Set the frame rate for the specified channel. The sum of the frame rate values from each
channel cannot exceed the maximum frame rates for a specific recording resolution.
Typical values of the maximum frame rate for video are Total 1080p@60fps or
720p@120fps.
* It is possible to use 1080p camera and 720p camera at the same time. Please note
that the system has to be booted after connecting all cameras on the system.
QUALITY
Select the recording quality for the specified channel. Options are: Level 1 (Low), 2, 3, 4
and 5 (High)
RECORDING
Assign the recording mode for each channel. Options are: Continuous, By Motion, By
Sensor, By Schedule or Disable.
SENSOR
RECORDING
Enable setting up to 4 sensors for the specified channel using the control button (◀ ▲
▶ ▼).
PRE
RECORD
Enable/disable pre-event recording. Pre-event recording time is 15 seconds to 20
minutes(Selectable)
POST EVENT
RECORD
Set the post event recording time duration for the specified channel. (10-30 seconds)
AUDIO
Enable/disable audio recording for the specified channel.
SCHEDULE
Set the recording schedule. Press SEL to go to schedule setup screen.