Manualshelf

Specifications

ManualsBrandsEneo ManualsData Input DevicesKBD-2
11121314151617181920
13
Com Ports
J-BOX :OFF J-BOX :ON
Com Ports
1. DOME1: DOME
2. DOME2: NONE
3. RS232: NONE
Save and Exit
Com Ports
1. DOME1: DOME
2 D2/DVR: NONE
3. ALARMPC: NONE
4. MUX/KBD: NONE
5. DVR/AUX: NONE
Save and Exit
J-BOX: OFF
DOME1
2400~38400
None / Dome / DVR5
DOME2
2400~38400 None / Dome / DVR1-4 / PC-DVR / KBDDUP / KBDTRI / AUX IN
RS232
2400~38400 None / DVR1-4 / PC-DVR / AUX IN
J-BOX: ON
DOME1
2400~38400 RS485: None / Dome
D2/DVR
2400~38400 RS485: None / Dome / DVR1-4 / PC DVR / AUX IN
ALARMPC
2400~38400 RS232: None / AUX IN
MUX/KBD
2400~38400 RS485: None / DUPLEX / TRIPLEX / AUX IN
DVR/AUX
2400~38400 RS232: None / DVR1-4 / PC-DVR / AUX IN
KBDDUP: Slave Keyboard + Duplex Multiplexer
KBDTRI: Keyboard + Triplex Multiplexer
AUX IN: Outputs the auxiliary signal input to Dome1 (FASTRAX, PELCO only)
NOTE: When the DVR is selected at a port, the other port displays the same DVR only. To change the DVR num ber at the other port, first change
the current DVR number to none.
MUX Config (Multiplexer Configuration)
This screen allows you to set multiplexer switching settings when you select the camera by pressing NO + CAM. Up to 64 Cameras can be installed using
5 MUXs and 4 keyboards. It is equivalent to a 64x4 matrix system. Each four users can view one of 64 cameras to his own SPOT(AUX) monitor.
MUX Config
1. MUX Channel: 16
2. Set MUX A
3. Set MUX B
Save and Exit
This menu is for assignment when multiplexers are installed in two levels. Two levels means that spot outputs of the first level multiplexers is connected to
the video input of the second level multiplexer.
Press NO + CAM will display the selected camera on the spot output of the second level multiplexer.
MUX Channel: NO (no use), 16, 28, 32, 48, 64 – Select the MUX channel number used in the multiplexer configuration.
When you select the desired number, the MUX configuration table is made automatically according to the number as the figures, page 15-17.
When the configuration is different from the auto-setting, you can change the value individually as below.