Product Manual

Page 7
4. Installing the ePOWER Inverter System
WARNING: ELECTRICAL SHOCK HAZARD
• The unit ‘On/O’ switch does not disconnect the DC power from the battery. To turn o the DC power to the
inverter either remove the main DC fuse or switch o the circuit breaker to disconnect the DC power from the
inverter before working on any circuits connected to the unit. Failure to follow these instructions can result
in death or serious injury.
CAUTION
• Reversing the DC Input terminal will damage the unit and cannot be repaired. Damage caused by reverse
polarity connection is not covered by the warranty.
Material Preparation for Installation:
Typical Wiring block diagram of the Enerdrive ePOWER Inverter:
-
- Negative
+
+ Positive
12V Battery Bank
Fuse or
Circuit
Breaker
USB
Loads
AC
Loads