Operation Guide

Installation and Operation Guide
A qualied technician is required to install the Remote Panel to the AC charger. Take caution when working
with batteries. Always disconnect the AC Power before you make any installation.
WARNING: Shock, re and energy hazards.
This Remote Panel is to be used with EN31220 / EN31240 / EN31260 / EN32430 Series for single charger
operation. NOTE: Only EN31260 & EN32430 Series are suitable for parallel charger operation.
Mounting the Remote Panel:
• Choose an appropriate mounting location.
• Use the wall cutout template and the Remote Panel mounting template to mark the positions of the
mounting holes.
For use with EN31220 / EN31240 / EN31260 / EN32430 Series with single charger unit
operation:
• Install the RJ12 Cable in your desired location.
• Connect one end of the RJ12 cable to ‘Com 1’ of Remote Panel.
• Secure the Remote Panel.
• Connect the other end of RJ12 cable to the ‘Remote’ port of the charger.
• The Remote Panel is now ready to use.
Important: The EN31220 / EN31240 Series cannot be operated in parallel, and ‘Com 2’ on the Remote Panel is
not used. Please do not connect the charger to ‘Com 2’, or connect a second charger to ‘Com 2’
Understanding the Remote Panel function:
For Remote Panel use on single charger unit operation:
• The remote panel controls and display the same functions as the display on the charger.
• When AC Power is connected to the charger, ‘Com 1’ LED on Remote Panel turns ON.
Page 1 (Version 3) - Aug 2015
ePOWER Battery Charger Remote Panel EN3REM