Manual
Enerdrive ePOWER B-Tec Lithium Battery- Owners Manual (Rev. 3.01)Page 4
1 GENERAL INFORMATION
Thank you for purchasing the Enerdrive ePOWER B-TEC Lithium battery. Please read the following
information carefully before installing your new battery.
This information denes the performance of the rechargable ePOWER LiFePO4 batteries distributed
by Enerdrive Pty Ltd and describes the type, performance, technical characteristics and warning of
the battery pack.
This battery is designed and intended only for use in deep cycle applications where a single battery
is required.
• The EPL-100BT-12V is equivalent to a 160Ah lead acid AGM deep cycle in usable capacity (50%DOD).
• The EPL-125BT-12V is equivalent to a 200Ah lead acid AGM deep cycle in usable capacity (50%DOD)
•
The EPL-200BT-12V is equivalent to a 360Ah lead acid AGM deep cycle in usable capacity (50%DOD)..
Suitable for Camper Trailers, 4WD’s (AUX battery), Caravans, Small water craft, Low power communication
sites or any application that requires the use of a deep cycle battery that meets the amp hour capacity.
The battery is equipped with a LiFePO4 Battery Management System (BMS) that can monitor and
optimize each single prismatic cell during charge & discharge to protect the battery pack from over
charge, over discharge & short circuit. The BMS helps to ensure safe and accurate operation of the battery.
Lithium batteries require specic charging algorithms. The charging source required must include the
correct charging algorithms and voltage parameters listed in the specication table below. Using the
incorrect charging source will damage the battery cells and void the warranty. Enerdrive can supply
AC mains, DC2DC chargers and solar controllers to suit all Lithium batteries available from Enerdrive.
Please contact Enerdrive for more information.
This Battery IS NOT designed for, nor should it be tted into an
engine bay or other area subject to high heat.
Damage WILL occur and not be covered by Enerdrive Warranty.