User Manual

Press and hold MENU button for
3 seconds to enter the
Charger Function Menu
For Lithium and Program
Battery Types refer to
Appendix A2
Press SEL to return to change current
Appendix A1
VERSION: REV. 1.00 - June 2017
Charger conguration is a simple step by step process as shown below.
For Tech Support call Enerdrive on 1300 851 535
NOTE: The current setting below is based on the EN3DC40+ battery charger.
Display will show recent setting.
CH1 BATTERY TYPE
CH1 BULK
CURRENT
Display shows GEL & Bulk
Voltage as currently set.
Display shows Bulk Current as
currently set.
Press SEL
to change
battery type
Press SEL
to enter high
current menu
Press SEL
to change
battery type
Press SEL
to change
battery type
Press SEL
to return to
battery type
Press SET to keep the current setting and toggle to the next menu
Press SET to keep the current setting and toggle to the next menu
Press SET to keep the current setting and toggle to the next menu
Press SET to keep the current setting and toggle to the next menu Press SET to keep the current setting and toggle to the next menu
Press SET to keep the current setting and toggle to the next menu
CH1 Battery Type
Please choose the type of battery to be charged.
Your choices are GEL, AGM, Flooded, Lithium or
Custom Program
Press SEL
to change
current
CH1 Bulk Current “h” setting
This setting is used to determine the maximum
output current that the charger is capable of. For
currents 40A or higher, this is achievable if the input/
output cables are large enough for the given distance
to carry the maximum voltage.
Choose between 5 to 50A (5A increments)
LEAD ACID MODE