User Manual

www.enerdrive.com.au

Page 7

Wiring Connections

1. Connect components to the charge controller in the sequence as shown above (1,2,3) and pay

particular attention to the “+” and “-”. Please don’t insert the fuse or turn on the breaker during the

installation. When disconnecting the system, the order will be reversed, (3,2,1).

2. The battery fuse should be installed as close to the battery as possible. The suggested distance is

within 150mm.

3. Always connect the battery rst, in order to allow the controller to recognize the system voltage.

4. Power up the controller and conrm that the LCD screen turns on. If the screen does not power

up, refer to page 14 TROUBLESHOOTING.

5. The ePOWER Solar Charge Controller is a common Positive Controller.

NOTE: If using an inverter, or have a load larger than the load output of the solar controller, connect the

inverter and/or large load/s directly to the battery.

USB

Charging

Cable

Fuse

Battery Bank

12V/24V

Breaker

Solar

Solar Controller

Phone or Tablet

Inverter

Load