Manual

ManualsBrandsEnergenics ManualsHardwareMLF-1015

www.energenics.com

1470 Don Street  Naples, Florida 34104 Telephone: (239) 643-1711

Fax: (239) 643-6081

Customer Service: (800) 944-1711

2009 Installation & Operation Manual

For MILNOR MLF-1004/1010/1015 On-board or Remote mounted

Individual Lint Filters

Descriptions Page

Table of Contents 1

Description of Lint Filter Operation 2

Important Installation Considerations

Receiving and Installation 3

Warnings/Cautions 4

Start Up and Operation Instructions

Typical On-Board Installation 5

Typical Remote Installation 6

Utilities Installation 7

Sheet Metal Installation 8

Compressed Air Requirements 9

Fire Suppression Water System 10

Dryer/Filter Utility Requirements 11

Side View Connection Location 12

IMPORTANT WARNING/GATE VALVE MAINTENANCE 13

Optional 6” Vacuum with 150 Gallon Lint Storage 14

Motor Starter Wiring for Optional Vacuum 15

Maintenance Requirements 16

Summary of content (16 pages)

PAGE 1
www.energenics.
PAGE 2
DESCRIPTION OF LINT FILTER OPERATION Your new Milnor Lint Filter represents the most advanced features available in the laundry industry to date. The following list the functions and mode of operation: Blowdown (cleaning) – The Lint Filter will automatically blowdown (clean) when the dryer blower motor stops at the end of the drying cycle. 30 seconds after the dryer blower stops the 6 second blowdown occurs.
PAGE 3
RECEIVING AND INSTALLATION Before you sign the Bill of Lading: 1. Receiving- Inspect units inside and out for signs of damage Verify all components are delivered per the Bill of Materials. Report damage to the carrier IMMEDIATELY. Note ALL damage on the Bill of Lading. This is your responsibility and you must file all claims. The filter is fully assembled and ready for installation. If the optional vacuum system is not ordered there will be a box with the Lint Bag and Installation Manual. 2.
PAGE 4
WARNING AND CAUTION IF INSTALLING OPTIONAL VACUUM PAY ATTENTION TO PAGE 15 You have purchased the finest lint filter available for your facility. Please follow these instructions to ensure a safe long life for your filter and facility. FAILURE TO FOLLOW THESE INSTRUCTIONS CAN RESULT IN AN UNSAFE OPERATING CONDITION, INCLUDING THE POSSIBILITY OF FIRE. DO NOT OPERATE ANY DRYER CONNNECTED TO THIS FILTER WITHOUT BEING CERTAIN THE FILTER STARTUP HAS BEEN COMPLETED AND THE FILTER IS IN OPERATING CONDITION.
PAGE 5
PAGE 6
PAGE 7
PAGE 8
PAGE 9
PAGE 10
PAGE 11
PAGE 12
PAGE 13
PIPING TO BE INSTALLED AS SHOWN ON PAGE 14. IF SYSTEM IS EQUIPPED WITH VACUUM, IT IS ABSOLUTELY ESSENTIAL TO INSTALL PVC TUBING IN A MANNER THAT WILL ALLOW THE GATE VALVE ASSEMBLY TO BE REMOVED FOR PERIODIC MAINTENANCE AND CLEANING. FOR CLEANING AND MAINTENANCE THE GATE ASSEMBLY MUST BE DISASSEMBLED BY REMOVING THE NUTS FROM THE HOUSING, REMOVING THE RUBBER SEALS AND BLOW COMPRESSED AIR ISIDE THE PLASTIC BODY. REASSEMBLE FOLLOWING THE REVERSE PROCEDURE APPLIED IN DISASSEMBLY.
PAGE 14
PAGE 15
PAGE 16
MAINTENANCE REQUIREMENTS The frequency of your maintenance requirements depends upon the number of hours of operation and upon variances in your product output. For a single-shift operation, without special problems, the frequency recommended below should suffice. You should set your own schedule based on your experience. 1. WEEKLY Visually inspect the filter inside and outside, its controls and their operation. At time of such inspection, note and correct any discrepancies from normal operation. 2.