Instruction manual

710W PLANER ENB466PLN
WARNING
Before carrying out any maintenance, ensure that the
power is off and the machine is unplugged from the
wall. Failure to do this could result in serious personal
injury
6. Changing the planer blades
The planer blades have two cutting edges and can be
reversed to make use of both sides.
Blunt or worn blades must be replaced or reversed
immediately. These blades cannot be sharpened and must
be replaced.
1.Remove the rebate depth guide and straight guide if fitted.
2.Turn the planer upside-down to access the blade bolts.
3.Loosen the 3 blade bolts 1(Fig.7) with the 8mm spanner
provided.(Fig8)
4.Loosen the 2 blade dolts 2(Fig.7) with the hex key
provided.(Fig.9)
5.Turn the blade holder until the blade is in line with the
blade groove on the side of the housing.
6.Push the first blade out of the blade holder by using a
small piece of wood or hex key(Fig.10). Do not attempt this
by hand.
7.Clean any dirt away that may have gathered.
8.Repeat the process for the second blade
9.Insert the reversed or replaced blades in reverse order by
pushing them into the groove sideways ensuring that they
are placed in the guide notches.
10.Ensure the blades are protruding equally at both ends of
the blade roller.
11.Secure the blades by tightening the 3 blade bolts. Do not
over tighten.
Caution
The blades should be changed regularly. In order not to
damage the machine, both blades should be changed at the
same time.
CAUTION!
The machine should be used only with both blades!
Blade bolts 1
Blade
Fig.7
Blade
bolts 2
Fig.8
Fig.9