Instruction manual

710W PLANER ENB466PLN
7. Installing and removing the dust bag(Fig.11)
The dust will be collected by the dust suction function during
use.
To assemble the dust bag, please follow below step
1. Push the dust bag connection nozzle (fitted to bust bag)
firmly over the dust extraction chute.
2. Push forward until it locks in place.
To remove the dust bag just pull out gently.
After emptying turn the bag inside out and shake.
Note: To ensure optimum dust collection, empty the dust
bag at approximately 2/3 full.
8. Drive belt replacement
The drive belt is expendable. It is keeping abrasion during
use.
The drive belt should be changed regularly.
CAUTION!
Replacing the drive belt should be done by authorized
service only.
The machine should be used only with drive belt!
To replace the drive belt, please fellow below steps:
1. Take away the drive belt cover by remove the fixing
screws.
2. Remove the damaged belt and use a soft brush to clean
the pulleys and the surrounding area.
3. With the three continuous “v” profiles on the inside, place
the new belt over the bottom pulley. Half fit the other end of
the belt on the top pulley then roll the belt in place whilst
turning the pulley.
4. Check that the belt runs evenly by manually turning the
belt and then re-assembly the drive belt cover.
5. Carry out a test run before starting work to ensure that the
tools are in good condition, correctly mounted and able to
turn freely. The trial run should be at last 60 seconds.
Fig.10
Fig.11