Instruction manual

1400W MITRE SAW ENB475MSW
manual may present a risk of personal injury.
22. Have your tools repaired by qualified person.
- This electric tool complies with the relevant safety rules. Repairs should only be carried
out by qualified persons using original spare parts, otherwise this may result in
considerable danger to the user.
SPECIAL SAFETY INSTRUCTIONS
1.If the supply cord is damaged, it must be replaced by the manufacturer, its service agent
or similarly qualified persons in order to avoid a hazard.
2. Only wood or products such as medium density fibre board can be cut with this saw.
Other materials may shatter or cause the blade to grab.
3. Never fit substandard blades to the saw. Only fit correctly sized saw blade.
4. Let the blade reach full speed before commencing the cut.
5. Do not use damaged or worn blades.
6. Ensure that the directional arrow marked on the blade corresponds with the rotational
direction of motor.
7. Ensure that the movable guards operate freely without jamming.
8. Never cut pieces too small to be held securely against the straight guide leave enough
space for the hand to be a safe distance from the blade.
9. Regularly check the blade securing bolt.
10. Do not run the machine with any part of the casing missing or damaged.
11. Do not start the saw when the blade is inserted into the workpiece.
12. Let the blade come to a complete stop before removing any jammed or offcut material
from around the blade area. Do not attempt to stop the blade by placing sideways pressure
on the blade disc.
13. Before cutting let the saw blade run freely for a few seconds. If it makes an unfamiliar
sound or vibration switch it off immediately and disconnect from the power supply.
Investigate cause or consult your dealer.
14. Ensure all securing clamps are tight and check for excessive play.
15. Never try to cut freehand. Always ensure that the workpiece is securely pressed
against the straight guide and table support surface.
16. Disconnect from the mains supply, pull down the handle of the saw. With the blade in
its furthest down position, rotate the blade by hand to ensure it is free from obstruction.
Repeat this procedure at all maximum mitre and bevel positions before commencing work.
17. Ensure that the workpiece to be cut off has sufficient room to move sideways. Failure
to do so may result in the off cut binding against the blade.
18. Ensure that irregular or round piece to be cut off has sufficient room to move or twist so
that they cannot pinch the blade.