Use and Care Manual

5a. (EZV2800 only, for EZV2200 proceed to step 5b)

Turn Power switch to "Start" for 5 seconds to start engine.

If the engine does not start, the battery may be dead,

proceed to step 5b to start the engine. Running the

engine charges the battery.

5b. Pull Recoil handle until engine starts. Several pulls may

be required until engine starts. Do not release the pull cord

at the end of a pull, this will damage the recoil assembly.

Bring the pull handle back down to the unit by hand.

6. Once the generator has started, wait at least 30

seconds for it to warm up, and then you may slowly open

the choke lever until it is fully open.

7. Connect all of your devices to the generator.

8. Turn EcoMode switch to "On". This will reduce the

output to a level where the generator will only produce

enough power for the connected devices. The reduction

of extra, unused power saves fuel.