User's Manual

8
2.3 Joining a ZigBee Smart Energy network
When your PowerTab is not joined to a network, it will display the
following screen:
To commission your PowerTab, follow the procedures supplied by your
service provider. Typical procedures will require the use of the display’s
Extended Unique Identifier (EUI-64) and its install code, both displayed
on the No Network screen.
When the commissioning process is complete, join the network by
holding <L> and <R> for three seconds at the No Network screen.
Note: It is advisable to keep your PowerTab connected to external
power while attempting to join a network to prevent any possible
interruptions due to power failure.
PART 2 – PowerTab Basics