User manual

6
1.1.4. Partitioning and Formatting Hard Disk Drive
Newly purchased hard disks are not usually formatted or partitioned. Non-formatted hard disks
cannot be detected by P2350; if so, follow the steps below to make it usable by P2350.
1. The HDD format tool is located in Setup
> System > HDD Format
2. To avoid mistakes and the loss of
valuable files you have to confirm the
formatting directive.
3. This step allows to specify the size of
the FAT32 and NTFS partitions. Note
that the FAT32 partition is required but
the NTFS not.
4. This is the last confirmation before
the actual formatting takes place.
Once started, wait about 2 minutes for
completion.
5. Once finished this message will appear.
Press OK to reboot.