SEKURY D850 SAI/UPS GB User manual
Sekury D850 KEEP THESE INSTRUCTIONS - Please read the following information carefully and save this manual for further reference. Disregard of these safety notes may endanger life or health, as well as the function of the equipment and the safety of your data. The UPS Sekury D850 provides full protection to your computer and peripherals, such as TFT screens, modems, routers and etc. Moreover, prevents data loss generated by blackouts, surge and other electrical disturbances.
2. PRODUCT OVERVIEW Front View: 2 1 1 Power Switch 2 UPS status LED - Normal mode (AC): green LED on. - Battery Mode: green LED flashing. Back View: 4 2 3 5 1 1 Protected Schuko outlets 2 USB port 3 AC input 4 RJ11 connectors for telephone/fax/ADSL protection 5 Rearm fuse 3. INSTALLATION AND INITIAL SETUP Before installation, please inspect the unit. Make sure that the UPS it’s in perfect conditions and free of any kind of external damages.
Connection to mains and charging Plug in the AC input cord to the wall outlet. This unit is shipped from the factory with its internal battery fully charged, however, some charge may be lost during shipping and the battery should be recharged prior to use. Plug the unit into an appropriate power supply and allow the UPS to charge fully by leaving it plugged in for at least 8 hours with no load (no electrical devices such as computers, monitors, etc.) connected.
4. IMPORTANT SAFETY INSTRUCTIONS ≥≥ Risk of Electric Shock. Do not open the UPS (except for battery replacement following the safety norms). ≥≥ Risk of Electric Shock. This unit receives power from more than one source. Disconnection of AC sources and the DC source is required to deenergize this unit before servicing. ≥≥ Risk of Electric Shock. Hazardous live parts inside this unit are energized from the battery supply even when the input AC power is disconnected.
5. MONITORING SOFTWARE SETUP Please do not connect the UPS to the computer USB port until the software setup process it’s finished. a) Install the monitoring software included in the CD-ROM. b) Follow the on-screen instructions to install the software. c) When your computer restarts, the monitoring software will appear as an orange plug icon located in the system tray. The UPS monitoring software installation guide and user manual can be found in the CD-ROM.
7. SPECIFICATIONS Model Sekury D850 CAPACITY INPUT Voltage Frequency Voltage Range OUTPUT Voltage Frequency Transfer Time Output waveform BATTERY Type Charging Time PHYSICAL Dimensions Weight ENVIRONMENTAL CONDITONS Temperature Humidity SOFTWARE 850 VA /480 W Compatibility 220/230/240 VAC 50 Hz/ 60 Hz 162-290 VAC 230V AC 50 Hz +/-1% Typical 2-6 ms Modified sinusoidal Sealed, acid battery, 12 V/9 AH x 1 8 hours to recover 90% of the capacity 287 x 100 x 142 mm 4.
Specifications are subject to change without notice. © 2009 by Energy Sistem Soyntec S.A.®. All rights reserved. Trademarks. All company, brand and product names are trademarks or registered trademarks of their respective companies. DECLARATION OF CONFORMITY Manufacturer Name: Energy Sistem Soyntec S.A. Address: Pol. Ind. Finestrat C/ Calpe esq.
