User manual

17
Connection to mains and charging
Plug in the AC input cord to the wall outlet. This unit is shipped from the factory with its internal battery
fully charged, however, some charge may be lost during shipping and the battery should be recharged
prior to use. Plug the unit into an appropriate power supply and allow the UPS to charge fully by leaving
it plugged in for at least 8 hours with no load (no electrical devices such as computers, monitors, etc.)
connected.
Devices connection
Plug in the devices to the outlets on the UPS rear panel. Simply switch on the UPS unit and the
devices connected to the UPS will be protected.
RJ-11 connection for Modem/Phone/ADSL surge protection
Connect a single modem/phone line into surge-protected “IN” outlet on the back panel of the UPS.
Connect from “OUT” port to the computer with another phone line cable.
Turn On/Off
Turn on the UPS unit by pressing the power switch. Turn off the UPS unit by pressing again the power
button.
Cold Start Function
The cold start function allows to power up your devices during blackouts. To use the cold start
function, just switch on the UPS, turn on you computer and peripherals as usual. The battery should have
enough charge in order to perform the start up of your connected devices.
CAUTION: NEVER connect a laser printer or scanner
to the UPS unit. This may cause unit damage.