Owners manual

Updated 1/FEB/02 BRH

May not be reproduced, in any form, or by any means,

without the written consent of Energy Suspension.

1131 VIA CALLEJON, SAN CLEMENTE, CA 92673

Installation Instructions

For set # 19.1103

Various Subaru Models 2003-

2016+ with Manual Transmission

Note: It is recommended that this set be professionally installed if you are unfamiliar with this type of work, and a factory

service manual be purchased prior to performing any work on your vehicle for proper disassembly, reassembly and torque

specs. These instructions are intended for bushing removal and install of Energy Suspension polyurethane bushings, once

you have removed the factory component from your vehicle.

17P17625

28/SEPT/16 BEL ECN#16063

Parts List:

1 - 01P01295 Rear Lower Crossmember Bushing (Thick)

3 - 01P01296 Crossmember Bushing all other positions (Thin)

1 - 17P17625 Instructions Sheet

Transmission Cross-member

bushings replacement:

Use a lift or jack stands to lift the

front of the vehicle and gain

access to the transmission cross-

members. Safely support the tail

end of the transmission with a

jack to relieve the weight from the

transmission mount. Remove the

brace which attaches to the

transmission cross-members and

transmission mount. Install new

bushings so that the locating

shoulders are opposite each other

and fit together. Reuse all factory

hardware and secure the brace

back to the cross-members and

transmission mount. Torque all

bolts and nuts to factory specs.

Remove transmission jack and

lower vehicle to the ground.

01P01295

01P01296