Owners manual

Installation instructions

For set # 2.7107

07-11 Jeep Wrangler JK

Rear Track Bar Bushings

17P17632 30/APR/14 BRH ECN 14044

1131 VIA CALLEJON, SAN CLEMENTE, CA 92673

Updated 8/JAN/03 BRH Updated 23/JAN/04 BRH

Updated 14/JAN/05 BRH Updated 10/JAN/06 BRH

Updated 2/JAN/07 BRH

May not be reproduced, in any form, or by any means,

without the written consent of Energy Suspension.

It is recommended that if you are unfamiliar with this type of work that you refer to a qualified service center specializing in this type of work.

It is also recommended that if you choose to do this work yourself that a factory service manual be obtained for the proper procedures

pertaining to removal, replacement and proper torque specifications for your vehicle. This instruction set is intended as a guideline for the

safe installation of Energy Suspension’s polyurethane bushings, once you have removed the factory components from your vehicle. Wheel

alignment is almost always disturbed when suspension components are removed or replaced. It is recommended that you have the

alignment checked on your vehicle at a qualified alignment shop. Energy Suspension recommends that you read over all the installation

instructions and check all P/N’s and quantities in the parts list before you start. Call customer service at 949-361-3935 if the parts in your kit

do not match this parts list. Prior to installation, make sure that your car is in excellent mechanical condition and that there are no suspension

or streeing related problems. This part has been designed to work only with a car that is in good state of repair. No matter how carefully we

design our parts, this is one area we have no control over and cannot be held responsible.

Properly support the vehicle on the frame. Unbolt the track bar from the vehicle.

bushings, including the outer metal shell the rubber is bonded to. The inside diameter of the track bar at both ends is Ø1.553”,

go about .050” smaller when pressing out the bushing. Clean the I.D. of both ends of the track bar that you just removed the

bushing from. Press in the supplied shells into the track bar and center them evenly (approximately .200” stick out on both

sides). Grease all sides of the bushing that contact metal. Press in the Energy Suspension bushings 7141, then grease the

sleeve and press into the bushings. Loosely install the track bar at axle tube bracket first with bolt & flange nut. It may be

necessary to pry the axle over to install the track bar at the frame rail bracket. Note: Frame bolt must be installed from rear to

front. Tighten the bolt at the frame and axle bracket to 169 N.m (125 ft. lbs.).

Use a hydraulic press to remove the original

Use a hydraulic press to remove the original bushings,

including the outer metal shell the rubber is bonded to.

Press in the supplied shells into the track bar and

center them evenly.

Parts list:

2 - 7141 (Track bar bushing)

2 - 15.02.49.39 (1.563” x .1.323” x

1.00” Shell)

2 - 15.10.392.39 (.875” x .563” x

1.600” Sleeve)

2 - 9.11108 (Grease)

Press in the Energy Suspension bushings 7141, then

grease the sleeve and press into the bushings.