Owners manual

Instruction Sheet #4.7128

Track Rod Bushing Set

ONE PIECE CAST STYLE ARMONE PIECE CAST STYLE ARM

WELDED STEEL STYLE ARMWELDED STEEL STYLE ARM

1131 VIA CALLEJON, SAN CLEMENTE, CA 92673

It is recommended that if you are unfamiliar with this type of work that you refer to a qualified service center specializing in this type of work.

It is also recommended that if you choose to do this work yourself that a factory service manual be obtained for the proper procedures

pertaining to removal, replacement and proper torque specifications for your vehicle. This instruction set is intended as a guideline for the

safe installation of Energy Suspension’s polyurethane bushings, once you have removed the factory components from your vehicle.

It is recommended that if you are unfamiliar with this type of work that you refer to a qualified service center specializing in this type of work.

It is also recommended that if you choose to do this work yourself that a factory service manual be obtained for the proper procedures

pertaining to removal, replacement and proper torque specifications for your vehicle. This instruction set is intended as a guideline for the

safe installation of Energy Suspension’s polyurethane bushings, once you have removed the factory components from your vehicle.

Remove original rubber/shell, Clean I.D. of eye of any old rubber or rust. When installing polyurethane bushings, apply grease as instructed:

Apply light coat of grease to I.D. of the rod-eye and the I.D. and O.D. of bushings (all surfaces that contact metal), and the O.D. Of the

sleeve. Install the bushing first then install the inner metal sleeve. Reinstall arms and tighten all bolts/nuts to factory specifications.

Remove original rubber/shell, Clean I.D. of eye of any old rubber or rust. When installing polyurethane bushings, apply grease as instructed:

Apply light coat of grease to I.D. of the rod-eye and the I.D. and O.D. of bushings (all surfaces that contact metal), and the O.D. Of the

sleeve. Install the bushing first then install the inner metal sleeve. Reinstall arms and tighten all bolts/nuts to factory specifications.

Updated 13/DEC/01 BRH

May not be reproduced, in any form, or by any means,

without the written consent of Energy Suspension.

May not be reproduced, in any form, or by any means,

without the written consent of Energy Suspension.

Updated 13/DEC/01 BRH

May not be reproduced, in any form, or by any means,

without the written consent of Energy Suspension.

May not be reproduced, in any form, or by any means,

without the written consent of Energy Suspension.

8268

8327

1.250”x0.807”x1.740”

123004

17433

NOTE: There will be two extra

bushings depending on

which arm you have, discard

the unused bushings.

NOTE: The supplied sleeve will

work for either type of arms.

NOTE: There will be two extra

bushings depending on

which arm you have, discard

the unused bushings.

NOTE: The supplied sleeve will

work for either type of arms.

15.10.466.39