Owners manual

3523
Inner bushing
3524
Outer bushing
Upper control arm
15.10.135.39
Sleeve
Parts list:
4 - 3521 Lower inner control arm bushing.
8 - 3522 Lower outer control arm bushing.
4 - 15.10.661.39 1.125” x .640” x 2.625” Sleeve.
4 - 3523 Upper inner control arm bushing.
8 - 3524 Upper outer control arm bushing.
4 - 15.10.135.39 .875” x .563” x 2.390” Sleeve.
3 - 9.11107 Grease.
1131 VIA CALLEJON, SAN CLEMENTE, CA 92673
R
Updated 8/JAN/03 BRH Updated 23/JAN/04 BRH
Updated 14/JAN/05 BRH Updated 10/JAN/06 BRH
Updated 2/JAN/07 BRH
2012 Energy Suspension. All rights reserved.
C
May not be reproduced, in any form, or by any means,
without the written consent of Energy Suspension.
Lightly grease the new polyurethane bushings. Upper Control Arm install 3523 first (inner bushing) then 3524 (outer bushings)
then sleeve 15.10.135.39 last (see diagram). Lower Control Arm install 3521 first (inner bushing) then 3522 (outer bushings)
then sleeve 15.10.661.39 last (see diagram). Install factory bolts and torque to factory specs.
Set vehicle on the ground.
Check & Retorque all bolt after 200
miles and again after 500 miles.
Be sure to align match-marks on
both sides of adjusting cams. It is recommended that you have the alignment checked on your
vehicle at a qualified alignment shop. The alignment must be within factory specifications.
Lower control arm
17590 Page 2 of 2
22/OCT/12 BRH
3524
Outer bushing
15.10.661.39
Sleeve
3522
Outer bushing
3522
Outer bushing
3521
Inner bushing
Apply grease to all metal parts that contact the polyurethane bushings
Tighten cam nut at the axle bracket to 217 N.m (160 ft. lbs.).
Tighten rear nut at the frame bracket to 217 N.m (160 ft. lbs.).
Tighten nut at the axle bracket to 163 N.m (120 ft. lbs.).
Tighten nut at frame bracket to 163 N.m (120 ft. lbs.).