Owners manual

Set # 5-4106
Note: When disassembling, note the quantity
and positions of any shims that may have
been inserted for body alignment. These
shims will have to be reused to insure proper
body alignment.
Remember: Only raise body high enough to
remove & replace mounts. Always watch the
fan shroud for sufficient clearance when
raising the body. When jacking the body use a
long enough 2X4 or 4X4 for maximum
support. Never put jack directly on body
panels.
Install mounts one side at a time with bolts on
other side loosened only.
Retorque to factory specs.
Removal
Must re-use original hardware.
POSITION # 1
Front of vehicle
OEM/Factory
washer-sleeve
OEM/Factory washer
Frame
4078
4085
Body
POSITION # 2-3
OEM/Factory
washer-sleeve
OEM/Factory washer
Frame
4078
4117
Body
3
2
1
17090
3/13/97 KN
Updated 21/JAN/02 BRH
Updated 13/DEC/01 BRH
2002 Energy Suspension. All rights reserved.2002 Energy Suspension. All rights reserved.
CC
May not be reproduced, in any form, or by any means,
without the written consent of Energy Suspension.
May not be reproduced, in any form, or by any means,
without the written consent of Energy Suspension.
1131 VIA CALLEJON, SAN CLEMENTE, CA 92673
R