Owners manual

Installation instructions
For set # 7.1
117
95-98 Nissan 240sx
Updated 8/JAN/03 BRH
2006 Energy Suspension. All rights reserved.2006 Energy Suspension. All rights reserved.
CC
May not be reproduced, in any form, or by any means,
without the written consent of Energy Suspension.
May not be reproduced, in any form, or by any means,
without the written consent of Energy Suspension.
1131 VIA CALLEJON, SAN CLEMENTE, CA 92673
R
Note: It is recommended that this set be professionally
installed if you are unfamiliar with this type of work, and a
factory service manual be purchased prior to performing any
work on your vehicle for proper disassembly, reassembly and
torque specs. These instructions are intended for bushing
removal and install of Energy Suspension polyurethane
bushings, once you have removed the factory component
from your vehicle.
17486
07/MAR/07
Using a hammer and cold chisel, remove
the 2 inner rings. Clean the remaining
rubber and rust prior to installing new
bushing.
NOTE: Do not bend the 6 metal tabs,
they need to support the new bushing.
Cut away the
rubber lip prior to
applying heat to
allow the old
bushing to come
out
Remove the stock bushings
from the sub frame using heat
rather than a hydraulic press
due to the size of the sub
frame.
Apply light heat evenly around
the outside of the outer metal
casing, just enough to brake
the bond with the rubber. When
you see light smoke coming
from the sides of the bushing
the bond should be broken. At
no time should there be any
flames coming from the rubber,
if there are any flames, you
need to back off with the heat.
Just push the old rubber and
inner metal sleeve out. Let the
outer metal casing cool off
before cleaning the inside.
4222
4223
Stock
Washer
TOP OF CAR
Part List:
4 - 4222 Upper frame bushing
4 - 4223 Lower frame bushing
4 - 15.10.578.39 Sleeve 1.250” x .858” x 2.710”
GREASE ALL PARTS THAT COME INTO
CONTACT WITH POLYURETHANE
NOTE: Take care not to use excessive heat
near other suspension components to avoid
melting vital rubber suspension bushings.
It may be necessary to remove the
suspension components from the sub frame
prior to applying heat.