Specifications

4P Molex

# 2

For IDE/SCSI/SAS drives or some AGP graphic card with traditional 4P power in

socket.

FDD

For floppy drive or certain add-on card.

FM (FAN RPM MONITOR)

# 3

For FAN RPM detection (1250W only).

#1 Some SATA drives might accept SATA or 4P Molex power. Normally, use either one of power

connector to power the driver, BUT NOT BOTH! Please check the drive’s manual for details.

#2 Some MB might require this connector to share the +12V current from 24-pin Mainboard

connector to PCI-E slot. If your MB already supports 24-pin Mainboard connector, you may not

need to add the 4P Molex connector on it. Please check the MB’s manual for details.

#3 Most MB offer 2 ~ 4 3-pin system/PSU fan power sockets, but only one or two socket(s) might

support the fan RPM signal. If you connect the PSU FM connector on the MB, but BIOS or

system monitor software cannot read the PSU fan RPM, please relocate the PSU FM connector to

another socket.

 MODULAR CABLES SUPPLIED

Use ONLY genuine ENERMAX modular cables coming with ENERMAX PSU. Third party cables

might not be compatible and might cause damage to your PSU and/or system, and use of third party

cable shall void PSU warranty.

EMC012: 3 x 4P Molex (IDE/SCSI) drives

Modular cable for IDE/SCSI/SAS drives and other peripherals.

EMC013: 3 x 4P Molex (IDE/SCSI) drives & 1 X FDD

connector

Modular cable for IDE/SCSI/SAS drives and peripheral, plus 1

FDD power connector.

EMC014: 2 x 6+2P (8P) PCI-E 2.0

Modular cable for 1 or 2 performance PCI Express graphic cards,

which needs 6P or 8P PCI-E connector.

EMC017: 4 x SATA drives

Modular cable for SATA/SAS drives like ODD and HDD.

 Supplied modular cables might differ by models and in different region.

 We offer more optional cables. Please visit our website for more information:

www.enermax.com

Special note for System Integrators:

If your system requires special modular cable configuration or

design, please contact an ENERMAX sales representative.

 ATTACHING / DETACHING THE MODULAR CABLES

Attaching the modular cable to PSU

5-pin / 12-pin connector on modular cable and PSU’s modular socket has an

arrow mark. To make correct connection is easy:

1. Black connector to black socket, and red to red.

2. Arrow mark to arrow mark.

3. Then you can easily plug in the connector.

ENGLISH